Tonebone Voco-Loco Preamp & FX Loop
Délais estimé avant expédition à confirmer une fois la commande placée.
Interest FREE financing available at checkoutTonebone Voco-Loco Preamp & FX Loop
The Radial Voco-Loco is in fact a studio quality preamp that has been carefully disguised as a foot pedal! One look at the linear frequency response, exceptional signal handling and low noise and you will recognize the studio quality that is built-in. This ensures that the dry microphone signal will be delivered to the PA system without distortion or artefact and faithfully reproduce the instrument or vocal without compromise. A carefully crafted 2-band EQ makes adjusting the tone effortless. Turning on the effects loop adds transformer isolation to reduce hum and buzz caused by ground loops, a common problem that plagues many pedal setups. Once the loop is brought back, a tone control lets you tame the effects signal and a dry-wet mix control lets you balance the signal to suit.
Specifications
| Specifications | ||
|---|---|---|
| Audio circuit type: | Integrated Op-Amp with Class A FET input circuit | |
| Frequency response: | 20Hz ~ 20kHz | |
| Dynamic range: | 100dB | |
| Gain: | 52dB | |
| Clip Level: | +15dBu | |
| Total harmonic distortion: | <0.005% | |
| Intermodulation Distortion: | <0.005% | |
| Phase Deviation: | 8 @50Hz | |
| Input Impedance: | 10K-Ohms, 100K (FX Loop) | |
| Output Impedance: | 300 Ohms, 3000 Ohms (FX Loop) | |
| Common Mode Rejection Ratio: | -73dB @55Hz | |
| Equivalent Input Noise: | -120dBu | |
| Noise: | -85dBu | |
| Maximum Input: | +10dB | |
| Features | ||
| Input pad, 180 polarity reverse, Ground lift, Effects Loop | ||
| Input Connectors: | XLR-F | |
| Output Connectors: | XLR-M | |
| General | ||
| Construction: | 14 gauge steel chassis and outer shell | |
| Power: | 100mA, center positive | |
| Conditions: | For use in dry locations only between 5C and 40C | |
| Warranty: | Radial 3-year, transferable | |